Your question: Where is the fire alarm pull?

NFPA 72 requires a pull station within 60 inches of every individual exit, and for groups of doors that are more than 40 feet wide away from each other, there must be a pull station on both sides of the grouping. The placement of fire alarm pull stations is critical to ensuring they provide the protection intended.

Where are fire alarm pull stations located?

Location – Manual fire alarm boxes (pull stations) shall be located not more than five feet from the entrance to each exit. Manual fire alarm boxes shall be located in each story including basements.

How do you pull a fire alarm?

To activate a Fire Alarm, pull the handle on one of the red fire alarm boxes. In all cases of fire, call 911 immediately. Someone must report the fire. Do not assume someone else is making this call, make the call yourself!!

How many pull stations are required?

The National Fire Protection Association (NFPA) 101 Life Safety Code requires at least one manual fire pull station in each building. The code states that a building should not entrust life safety to only one safeguard, and directs that additional safeguards be implemented.

When should I pull my fire alarm?

The detection devices are very sensitive and the Fire Alarm System provides you with an early warning of an emergency situation. Even if your area is clear of any smoke or odor, do not disregard the alarm, as there could be an incident on a floor away from your area.

IMPORTANT:  Do firemen replace smoke alarm batteries?

How do I make my fire alarm stop beeping?

Resetting the Alarm

  1. Turn off the power to the smoke alarm at the circuit breaker.
  2. Remove the smoke alarm from the mounting bracket and disconnect the power.
  3. Remove the battery.
  4. Press and hold the test button for at least 15 seconds. …
  5. Reconnect the power and reinstall the battery.

How do you turn off a fire alarm manually?

How to Turn Off Smoke Alarm

  1. Get where your circuit breaker is and turn the power off to the fire alarm.
  2. Disconnect the power supply by detaching the detector from its mounting bracket. …
  3. In case your fire alarm uses a battery, remove it.
  4. Keep the test button pressed for 15 to 20 seconds (with the battery out).

What is the maximum distance between pull stations?

NFPA 72 refers to fire alarm pull stations as “manual fire alarm boxes.” The code requires that the travel distance to the nearest pull station on a given floor must be no more than 200 feet. So, the larger the building and the longer its hallways, the more pull stations will be required.

What is manual call point?

A manual call point is a device which enables personnel to raise an alarm in the event of a fire incident by pressing a frangible element to activate the alarm system.

Fire safety